Ethernet network interface troubleshooting, Power-up troubleshooting – Genicom LN45 User Manual

Page 168

Advertising
background image

Publication No. GEG-99126

Genicom

Aug 01

6-30

GENICOM LN45 and Intelliprint mL450 User Guide
Ethernet Network Interface Troubleshooting

NOTE:

1: These faults are not necessarily hard faults. They only become hard faults when an attempt is
made to use the “faulted” device. For these errors, the printing can continue if one simply
avoids the problem. For instance, “tray trouble” faults usually indicate that the tray in question
has been removed. These errors are only treated as faults when there is no alternative action to
take. Your printer may be configured so that the problem is easily avoided. When the problem
cannot be avoided, the described faults will be displayed.

2: The Communications Error indicates an error that requires a service call. However, before
arranging for a service call, ensure that all associated cabling is correctly installed.

3: The Finisher errors are reported when an attempt is made to use the finisher.

Ethernet Network Interface Troubleshooting

This section offers various troubleshooting procedures and technical support advice for the Ethernet net-
work interface.

Power-Up Troubleshooting

There are several possible error situations if the unit does not display the welcome message or the LEDs do
not flash:

Error Messages

Message

Diagnosis/Remedy

Power-up diagnostic failure (hardware
failure)

Note which LED is blinking and its color, then
contact your dealer or Technical Support.

The network interface boots but does
not try to load the Flash ROM code

Briefly press the Test button on the network
interface’s I/O panel. A network interface
configuration page will be printed. (To press the Test
button, you will need a pointed object - e.g. paper
clip.)

Network Error: The ACT LED will blink
yellow 2-3 times per second

A. Make sure the Ethernet network cable is properly
connected and reboot the server.

B. If option A fails to resolve the problem, reload
Flash ROM. Refer to the Updating Software chapter
of the

Ethernet Network Interface Reference

Manual

.

Advertising
This manual is related to the following products: