Lp conversion, Lp conversion gas cooktop instructions, Before you begin – GE JGP985 User Manual

Page 30: For your safety, Important, Warning

Advertising
background image

30

Questions? Call 800.GE.CARES (800.432.2737)

or

Visit our Website at:

www.GEAppliances.com

LP Conversion

Gas Cooktop

Instructions

Read these instructions completely and carefully.

IMPORTANT –

Save these

instructions for local inspector’s use.

IMPORTANT –

Observe all

governing codes and ordinances.

Note to Installer –

Be sure to leave these

instructions with the Consumer.

Note to Consumer –

Keep these

instructions for future reference.

BEFORE YOU BEGIN

This cooktop is factory set for natural gas operation.

Conversion to LP operation should be performed by
a qualified technician or installer. Keep these
instructions for future reference. When converting
to LP, save the original parts for possible future use.

Product failure due to improper installation is not

covered under the GE Appliance Warranty.

JGP985

WARNING –

If you are using LP (bottled)

gas, all adjustments described in the following steps must
be made before attempting burner adjustments or use of
the cooktop.

WARNING –

This conversion kit shall be

installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions is
not followed exactly, a fire, explosion or production
of carbon monoxide may result, causing property
damage, personal injury or loss of life. The qualified
service agency is responsible for the proper installation
of this kit. The installation is not proper and complete
until the operation of the converted appliance is
checked as specified in the manufacturer’s instructions
supplied with the kit.

FOR YOUR SAFETY:

Adjustable wrench

TOOLS YOU WILL NEED

PART

QUANTITY

Brass orifices

4

Stick-on conversion label

1

PARTS INCLUDED

Small, thin-blade flat screwdriver with approximately 1/8

blade width is needed to access the calibration screw.

Advertising