Stovax Ceramica Coal Effect Stove Range Conventional Flue - Manual (Page 11)

11
3.5 Remove the assembly and drill the two holes using a No. 12
masonry bit. Push the rawl plugs into the holes, and place
the engine assembly in position, secure to the floor using
the screws provided. See diagram 3.
3.6 Having run the gas supply to the stove, PURGE THE
SUPPLY PIPE, this is essential to expel any debris that may
block the gas controls. connect the gas supply to the 8mm-
compression elbow at the RH rear corner of the stove,
ensuring that the pipe position does not interfere with the
location of the outer steel casing. See diagram 4.
3.7 Open the second carton, and carefully remove the ceramic
outer casing components. Gently position the LH side so
that the bolt heads on the engine subframe locate in the
keyhole slots on the back of the panel, and gently slide into
place so that the ceramic comes to rest on the floor. Repeat
the procedure for the RH side, see diagram 5.
3.8 Remove the cast iron door using the tool provided, and
carefully place to one side. Gently position the front
ceramic panel so that the side panels locate inside the
returns on the front panel, engage the bolt heads in the
brackets on the back of the panel and gently slide into
place so that the ceramic comes to rest on the floor, ensure
that the opening in the panel sits centrally around the fire
box opening, see diagram 6.
INSTALLATION INSTRUCTIONS
INSTALLATION
4
3
AR0359
5
6
158mm