Garmin STYLUS 3880 - Manual (Page 18)

18 Setting Up Your System for Network Printing
7. Press r , then press u or d to choose one of the following IP configuration
settings:
❏
Choose AUTO if your network uses a DHCP server to provide IP
addresses automatically. The printer’s IP address will be obtained from
the DHCP server whenever the printer is reset or turned on, but may
change as IP addresses are reassigned over time.
❏
Choose PANEL if you would like to set the printer’s IP settings
manually (recommended).
❏
Choose PING to set the printer’s IP address using the arp command.
The IP address is set when the printer is turned off and then back on.
8. Press . An asterisk ( ) appears next to the setting you selected.
9. Press l to go back, then do one of the following:
❏
If you selected AUTO as the IP address setting, press the
+
Cancel/Reset button to exit the printer menu. Then continue with step
14.
❏
If you selected PANEL as the IP address setting, continue with step 10.
❏
If you selected PING as the IP address setting, press the
+
Cancel/Reset button to exit the printer menu. Print a network status
sheet to determine the printer’s MAC address (see “Printing a Network
Status Sheet” on page 19). Then use the arp command to set the IP
address from a computer on the same segment of your network as the
printer. Type the arp command on the command line using this format
(where X is the IP address you want to assign and Y is the MAC
address):
arp -s XXX.XXX.XXX.XXX YY-YY-YY-YY-YY-YY
After typing the command, continue with step 14.
10. Press d to highlight IP,SM,DG SETTING, then press r . The LCD displays
the IP address.
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r . The
LCD displays the subnet mask.
*