General warnings and safety information, Electrical, Mechanical – GE 263 User Manual

Page 4

Advertising
background image

4

General Warnings And Safety Information

Rev A

General Warnings And Safety Information

Electrical

There are no user-serviceable parts in the AC adapter, motor, or controller.
In the event of a failure, these should be replaced.
•

All electrical connections must be completed according to local codes.

•

Use only the power AC adapter that is supplied.

•

The power outlet must be grounded.

•

To disconnect power, unplug the AC adapter from its power source.

Mechanical

•

Do not use petroleum based lubricants such as vaseline, oils, or
hydrocarbon based lubricants. Use only 100% silicone lubricants.

•

All plastic connections should be hand tightened. Teflon tape may be
used on connections that do not use an O-ring seal. Do not use pliers
or pipe wrenches.

•

All plumbing must be completed according to local codes.

•

Soldering near the drain line should be done before connecting the
drain line to the valve. Excessive heat will cause interior damage to the
valve.

•

Observe drain line requirements.

•

Do not use lead-based solder for sweat solder connections.

•

The drain line must be a minimum of 1/2-inch diameter. Use
3/4-inch pipe if the backwash flow rate is greater than 7 GPM
(26.5 Lpm) or the pipe length is greater than 20 feet (6 m).

•

Do not support the weight of the system on the control valve fittings,
plumbing, or the bypass.

•

It is not recommended to use sealants on the threads. Use Teflon*
tape on the threads of the 1-inch NPT elbow, the drain line
connections, and other NPT threads.

*Teflon is a trademark of E.I. duPont de Nemours.

Advertising
This manual is related to the following products: