Greenway Home Products GWF7 - Manual (Page 3)

2
OPERATING INSTRUCTIONS
Getting your Water Dispenser Ready for the Greenway ® Water
Filtration System
IMPORTANT: The Greenway ® Water Filtration System is designed to fit
all Greenway ® water dispensers and most other brand names.
Depending on your water dispenser, you may have to remove
the bottle support collar and/or piercing valve from your dispenser in
order for the filtration system to fit. (See FIGURE A, page 5.)
CAUTION! Once the filtration system is placed on the water dispenser
it should fit level and secure. The float mechanism that fits inside the
water dispenser must NEVER be obstructed and be allowed to operate
freely!
GETTING STARTED
Wash all parts in warm soapy water before initial use. Rinse and dry
thoroughly. THE PARTS ARE NOT DISHWASHER SAFE!
IMPORTANT
• DO NOT WASH the multi-stage filter or pre-filtration parts.
• Soak the multi-stage filter in cold tap water for 30 minutes
before using.
• FLUSH the filter under the tap for 30 seconds and shake gently.
ELECTRONIC FILTER CHANGE REMINDER
To turn on the electronic filter change reminder, press the “reset”
button until 180D flashes on the display. The counter will begin to
count down the days from 180 and will be decreased by 1 day every
24 hours until the display reads 0000D. It will then be time to replace
your filter. The same procedure applies for resetting the filter change
reminder after a filter has been changed.
Greenway ® Long Life Multi-Stage
Replacement Filter:
GWF3
Available online at
www.greenwayhp.com