Navigating with a garmin autopilot – Garmin GPSMAP 740s User Manual

Page 36

Advertising
background image

32

GPSMAP 700 Series Owner’s Manual

Navigation

Managing the Track Log Memory During Recording

1. From the Home screen, select Information > User Data > Tracks > Active Track options > Record

Mode.

2. Complete an action:

• Select Fill to record a track log until the track memory is full.
• Select Wrap to continuously record a track log, replacing the oldest track data with new data.

Configuring the Recording Interval of the Track Log

You can indicate the frequency at which the track plot is recorded. Recording more-frequent plots is more

accurate but fills the track log faster. The Resolution interval is recommended for the most-efficient use of

memory.
1. From the Home screen, select Information > User Data > Tracks > Active Track options > Interval >

Interval.

2. Complete an action:

• Select Distance to record the track based on a distance between points, select Change, and enter the

distance.

• Select Time to record the track based on a time interval, select Change, and enter the time interval.
• Select Resolution to record the track plot based on a variance from your course. Select Change to enter

the maximum error allowed from the true course before recording a track point.

3. Select Done.
Copying Tracks

See “Chartplotter Data Management” (

page 52

).

Deleting All Saved Waypoints, Routes, and Tracks

From the Home screen, select Information > User Data > Clear User Data > All > oK.

Navigating with a Garmin Autopilot

When you start navigation (Go To, Route To, or Guide To), if you are connected through a National Marine

Electronics Association (NMEA) 2000 network to a compatible Garmin autopilot (such as the GHP

10), you

are prompted to engage the autopilot.

Advertising
This manual is related to the following products: