Graco 9651 & 9744 User Manual

Pack ’n play, Bassinet and canopy, Owner’s manual

Advertising
background image

2

3

4

© 1999 Graco 374-7-99

Congratulations on your purchase of a

Graco

®

Pack ’N Play

®

!

Graco is the recognized leader in the

design and manufacture of quality baby

products. We believe your new Graco

®

Pack ’N Play

®

is a wise choice, promising

many hours of enjoyment for your baby.
Your Pack ’N Play

®

may be used as a playard,

portable crib, bassinet or canopy unit.

Customer Satisfaction

Our goal is to make every product the best it

can be! We are also committed to supporting our

products after purchase. If you would like to speak

to Graco about your product, please contact our

Customer Service Department at 1-800-345-4109

or visit our Internet website, www.gracobaby.com.

Our knowledgeable staff will be ready to answer

any questions you may have concerning parts, use,

or maintenance. When you call, please have the

model and serial numbers ready so your call may

be processed quickly and efficiently.

Model Nos. 9651 & 9744

Model No. _________

Serial No. _________
Dear Customer,

Please fill in the model and serial numbers

above from the label in the center of the

bottom of your new Pack ’N Play.

Pack ’N Play

®

Bassinet and Canopy

Read all instructions BEFORE

assembly and use of this product.

Keep instructions for future use.

We recommend that you keep these instructions

with your Pack ’N Play. A storage pocket has been

provided for them on the bottom panel of your unit.

Failure to follow these warnings and the assembly

instructions could result in serious injury or death.

Setting Up the Pack ’N Play

! THIS PRODUCT REQUIRES ADULT ASSEMBLY.
! Keep fingers clear of top corners during setup.

Be sure Pack ’N Play is completely set up before use.

Check that the four top rails are completely latched, the

center of the floor is pushed down, and the mattress is

flat and secured by the

VELCRO

®

straps. Always follow

the instructions in the owner’s manual to set up the

Pack ’N Play.

! When using a bassinet make sure

VELCRO

®

patches

underneath mattress firmly attach to bassinet mesh.

! Before each use, inspect this product for damaged

hardware, loose joints, missing parts or sharp edges.

Do not use Pack ’N Play if any parts are missing

or broken. Call 1-800-345-4109 for replacement parts or

owner’s manual. Do not substitute parts.

Using the Pack ’N Play

! The Pack ’N Play can be used as a playard, bassinet or

sleeping crib. When used as a playard, never leave child

unattended and always keep child in view. When used as

a sleeping crib or bassinet, you must still provide the

supervision necessary for the continued safety of your

child.

! Always keep the Pack ’N Play away from hazards in the

area that may injure your child.

! Do not add padding or other objects inside the Pack ’N

Play that will permit your child to climb out.

! Stop using this product when your child reaches 35 inches

(89 cm) in height, weighs more than 30 pounds (14 kg), or

is able to climb out.

! Do not modify Pack ’N Play or add any attachments

that are not listed in the owner’s manual, including an

add-on bassinet.

Using the Bassinet

! Use bassinet with only one child at a time.
! Never place a child under the bassinet.

! The bassinet must be fully assembled and installed,

including top rails, snaps and bottom pad, before using.

! Discontinue using your bassinet if child weighs over

15 lbs. (6.8 kg), can roll over, or can push up on hands

and knees.

! DO NOT store the bassinet in the Pack ’N Play while in

use. Store rails in pocket in the bassinet.

! To help prevent heat build-up inside the playard and to

avoid overheating your child, when using the bassinet DO

NOT use a canopy.

Avoiding Suffocation Hazards

! Unlike cribs that have rigid sides, the Pack ’N Play and

the bassinet have flexible sides. As a result, the Pack ’N

Play mattress is specially designed to prevent suffocation.

The Pack ’N Play mattress has a solid base, a certain

length and width, and is less than one inch thick in order

to meet safety standards. Using a thicker or a different

sized mattress may allow a child’s head to get between

mattress and the side of the Pack ’N Play or bassinet

causing suffocation.

! To help prevent suffocation from entrapment,

USE ONLY THE MATTRESS PROVIDED BY GRACO.

Never use additional mattress or padding.

! Never use plastic shipping bags or other plastic film as

mattress covers not sold and intended for that purpose.

They can cause suffocation.

! Do not use a water mattress with the Pack ’N Play.

Avoiding Strangulation Hazards

! Strings and cords can cause strangulation. Keep strings

and cords away from child.
! Do not place the Pack ’N Play near a window where

cords from blinds or drapes can strangle a child.

! Do not hang strings on or over the Pack ’N Play.

! Do not place items with a string around a child’s neck,

such as hood strings, pacifier cords, etc.

! Do not attach strings to toys.

This product is not intended for commercial use.

Failure to follow these warnings and

instructions could result in serious injury or death.

To Set Up Your Pack ’N Play

®

Step 1.

Undo the three

VELCRO

®

straps. Fold

VELCRO

®

straps

back onto themselves.
Set mattress aside.

Step 2.

IMPORTANT: Leave

center of floor UP

until all four top

rails are latched.

Grasp the bottom of two

of the top rails, and pull

up until you hear a “click.”
Be sure top rails

have become rigid.
If not, pull up again

until they are rigid.

Top rail

FOR SMOOTH SETUP and takedown, it’s

important to remember one thing: the center

of the floor must be at least halfway up when

locking OR unlocking rails (see picture below).

Therefore:
!! When setting up, lock rails

BEFORE lowering center.

!! When taking down, raise center halfway

BEFORE unlocking rails.

Step 3.

Pull up the other two sides

until they latch.
If top rails do not latch,

lift the center of the floor

higher. Center of floor

must be at least halfway

up for the latches to catch

properly.
Be sure all top rails are

rigid.

Step 4.

Hold one end of the

unit up and push the

center of the floor down.

Setting up the Pack ’N Play

®

is easy,

once you know how:

OWNER’S

MANUAL

Advertising