Graco 9651 & 9744 - Manual (Page 7)

13 374-7-99 14 15 16
Side mesh
panel
Canopy mesh
Front mesh
panel
To Set Up and Use Your Canopy
When properly used, the canopy provides shade for
your child. However, your child may be warmer inside
the playard than in a shaded area outside the playard.
To help prevent build-up of heat inside the playard and
to avoid over-heating your child:
! Turn canopy mesh away from the sun. Keep entire
mattress shaded from sunlight at all times.
! Keep playard well ventilated:
! Always keep the front mesh panel and one side
mesh panel of the playard open.
! Never cover the canopy mesh.
! Never use the canopy with a bassinet in use.
As always, use good judgment to protect your child
from exposure to heat which can lead to serious injury
or death.
NEVER leave your child unattended.
ALWAYS keep your child in view.
Side mesh
panel
Canopy mesh
Front mesh
panel
Step 1.
Unfold the tubing and slide
the three sections together to
form one long tube. The
elastic cord in the tubing will
hold the pieces together.
Step 2.
Slide the long tube into the
tunnel in the canopy until
both ends stick out of the
tunnel 3 or 4 inches
(7.5-10 cm). The tunnel is
on the shiny side near the
netting.
Step 3.
Push the tube ends into
the corner brackets on the
Pack ’N Play. Tube end caps
will snap into place in the
brackets.
The mesh side of the canopy
goes on the same side of the
unit as the brackets. The
shiny side goes on the inside
of the unit.
To remove canopy, first
grasp tube firmly so that it
will not spring out. Then push
in on end caps to release
them from brackets and pull
tube ends up.
Step 4.
Pull the back corners of the
canopy over the back corners
of the Pack ’N Play and fasten
the VELCRO ® squares located
on the ends of the top rail and
back corners of the canopy.
Canopy Tubing
Step 5.
To help prevent build-up of heat inside the playard and to
avoid over-heating your child:
! Never use the canopy with a bassinet in use.
! Turn canopy mesh away from the sun. Keep the entire
mattress shaded from sunlight at all times.
! Keep playard well ventilated:
! Always keep the front mesh panel and one side mesh
panel of the playard open.
! Never cover the canopy mesh.
Maintenance of Canopy:
DO NOT machine wash or dry in a dryer.
DO NOT dry clean. Spot clean with a damp
cloth and a mild detergent. NO BLEACH.
Push in, then up
To fold the top rail:
!
Lift up slightly on the top rail.
!
Push up on the button located under the symbol
!
to release the two tubes.
!
Push down.
To Fold Your Pack ’N Play ®
Step 1.
Lower the back flap. Apply
locks on wheels. Release the
two VELCRO ® straps under the
Pack ’N Play, and remove the
mattress.
Step 2.
IMPORTANT:
Raise center halfway
BEFORE unlocking
rails.
Grasp the red handle
on the center of the floor
as shown.
Push down and turn
handle. Then pull up
approximately halfway
to the top rails.
Center
piece
Tube
Push UP button
under fabric
Step 3.
The top rail has a center piece
with two tubes hidden under
the fabric. The button on the
bottom of the center piece
releases the two tubes when
it is pushed up.
!
If top rails do not unlatch, lift
!
the center of the floor higher.
!
Both tubes must be released
!
for the top rail to fold.
Step 4.
Pull center up all the way.