GoVideo DDV3120 - Manual (Page 6)

iv Dual-Deck VCR User’s Guide
O U T D O O R A N T E N N A
G R O U N D I N G
If an outside antenna or cable system is
connected to the product, be sure the antenna
or cable system is grounded so as to provide
some protection against voltage surges and
built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70,
provides information with regard to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna-discharge unit, connection
to grounding electrodes, and requirements for
the grounding electrode. See figure above.
L I G H T N I N G
For added protection for this product during a
lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet and disconnect the antenna
or cable system. This will prevent damage to
the product due to lightning and power lines
surges.
P O W E R L I N E S
An outside antenna system should not be
located in the vicinity of overhead power lines
or other electric light or power circuits, or where
it can fall into such power lines or circuits. When
installing an outside antenna system, extreme
care should be taken to keep from touching such
power lines or circuits as contact with them
might be fatal.
O V E R L O A D I N G
Do not overload wall outlets, extension cords,
or integral convenience receptacles as this can
result in a risk of fire or electric shock.
O B J E C T A N D L I Q U I D E N T R Y
Never push objects of any kind into this product
through openings as they may touch dangerous
voltage points or short-out parts that could
result in a fire or electric shock. Never spill liquid
of any kind on the product.
S E R V I C I N G
Do not attempt to service this product yourself
as opening or removing covers may expose you
to dangerous voltage or other hazards. Refer
all servicing to qualified service personnel.
D A M A G E R E Q U I R I N G S E R V I C E
Unplug this product from the wall outlet and
refer servicing to qualified service personnel
under the following conditions:
a When the power-supply cord or plug is
damaged,
b If liquid has been spilled, or objects have
fallen into the product,
c If the product has been exposed to rain or
water,
d If the product does not operate normally by
following the operating instructions. Adjust
only those controls that are covered by the
operating instructions as an improper
adjustment of other controls may result in
damage and will often require extensive work
by a qualified technician to restore the
product to its normal operation,
e If the product has been dropped or
damaged in any way, and
f When the product exhibits a distinct change
in performance - this indicates a need for
service.
R E P L A C E M E N T P A R T S
When replacement parts are required, be sure
the service technician has used replacement
parts specified by the manufacturer or have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock, or other hazards.
S A F E T Y C H E C K
Upon completion of any service or repairs to
this product, ask the service technician to
perform safety checks to determine that the
product is in proper operating condition.
W A L L O R C E I L I N G M O U N T I N G
The product should be mounted to a wall or
ceiling only as recommended by the
manufacturer.
H E A T
The product should be situated away from heat
sources such as radiators, heat registers, stoves,
or other products (including amplifiers) that
produce heat.