Graco Inc. Husky 239126 - Manual (Page 2)

2 308703
Table of Contents
Symbols 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warnings 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service 10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Model Numbers 12 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Matrix 13 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Drawings 14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dimensions 16 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical Data 17 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco Standard Warranty 18 . . . . . . . . . . . . . . . . . . . . . .
Graco Information 18 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
D
This equipment is for professional use only.
D Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated component in your system. This
equipment has a 120 psi (0.8 MPa, 8 bar) maximum working pressure and 120 psi (0.8 MPa,
8 bar) maximum incoming air pressure.
D
Solvent Compatibility:
– Use fluids and solvents which are compatible with the equipment wetted parts.
– Use only compatible solvents to clean all plastic parts. Many solvents can degrade plastic
parts to the point where they could fail.
Refer to the Technical Data section of all equipment manuals. Read the fluid and solvent
manufacturer’s warnings.
D Do not use hoses to pull equipment.
D Do not lift pressurized equipment.
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
D Do not operate outside the minimum and maximum operating temperature of your surge
suppressor unit. See Minimum and Maximum Operating Temperatures on page 7.