Genie TZ-50 - Manual (Page 20)

18 Genie TZ-50 Part No. 82900
Operator's Manual First Edition • Sixth Printing
FUNCTION TESTS
Test Outrigger Interlock
23 Place the boom in the stowed position.
24 Push and hold the blue function enable button.
Push and hold one outrigger button and raise
the outrigger off the ground.
25 Push and hold the blue function enable button
and activate each boom function.
Result: All boom functions should not operate.
26 Use the leveling buttons to lower the outrigger.
27 Repeat this procedure for each outrigger.
28 Use the function enable buttons and the auto
level button or the outrigger leveling buttons to
make sure the machine is level.
29 Raise the platform approximately 2 feet / 60 cm.
30 Push and hold the blue function enable button
and attempt to raise each outrigger off the
ground.
Result: The outriggers should not raise.
Test the Tilt Sensor
31 Raise the boom 2 feet / 60 cm.
32 Turn the key switch to
platform control.
33 Locate the tilt sensor below
the ground control box. It is
the sensor farthest to the left.
34 Press down one side of the
tilt sensor.
Result: The alarm should sound.
35 Lower the boom.
At the Platform Controls
36 Pull out the platform red Emergency Stop button
to the on position.
Test Emergency Stop
37 Push in the platform red Emergency Stop button
to the off position.
Result: All platform control functions should not
operate.
38 Pull out the platform red Emergency Stop button
to the on position.
Test Boom Functions and Function Enable
39 Do not push a function enable button. Attempt to
activate each boom function button.
Result: All boom functions should not operate.
40 Push and hold the blue function enable button.
Activate each boom function button.
Result: Primary boom up, primary boom extend,
secondary boom up, platform level up, jib boom
up, platform rotate left and turntable rotate left
should all function.
41 Push and hold the yellow function enable button.
Activate each boom function button.
Result: Primary boom down, primary boom
retract, secondary boom down, platform level
down, jib boom down, platform rotate right and
turntable rotate right should all function.