Genie TZ-50 - Manual (Page 27)

Part No. 82900 Genie TZ-50 25
Operator's Manual First Edition • Sixth Printing
OPERATING INSTRUCTIONS
Towing
1 Set the parking brake.
2 Secure the boom with the hold-down latches.
3 Models with platform rotate: Make sure the
platform is in the center position. If the platform
is off center, the taillights may not be visible on
the road.
4 Raise the tongue by turning the jack handle.
5 Position the ball of the transport vehicle directly
under the ball coupler.
6 Open the latch on the ball coupler.
7 Lower the tongue by turning the jack handle.
8 Close the latch on the ball coupler.
9 Attach the safety chains (if required) and the
brake cables to the vehicle. Cross the chains
under the hitch.
10 Pull the jack release handle and rotate the
tongue jack to the stowed position.
11 Connect and test the trailer lights.
12 Release the parking brake.
Backing Up with Hydraulic
Surge Brake (ANSI models)
If your machine is equipped with a hydraulic surge
brake, the system must be released before backing
up.
Consult the surge brake system manual for specific
instructions on each surge brake.
Be sure that the machine is returned to towing or
operating configuration when finished.
After Each Use
1 Rotate the turntable so that the platform is
opposite the tongue of the machine.
2 Lower the boom into the mast cradles.
3 Secure the boom with the hold-down latches.
4 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
5 Charge the batteries (if necessary).
Storage
1 Make sure the boom is properly stowed and the
hold-down latches are secured.
2 Raise and stow the outriggers.
3 Select a safe parking location—firm level
surface, clear of obstructions and traffic.
4 Turn the key switch to the off position and
remove the key to secure from unauthorized
use.
5 Chock the wheels.
6 Charge the batteries (if necessary).
Moving Machine Without a Tow
Vehicle
Do not attempt to manually move a machine unless
it is on a firm, level surface. Use the parking brake
to control the speed of the machine while pushing
it.