Genie TZ-50 - Manual (Page 26)

24 Genie TZ-50 Part No. 114164
Operator's Manual Second Edition • First Printing
Platform Overload Indicator Light
(if equipped)
Light flashing indicates the platform
is overloaded and no functions will
operate.
Remove weight from the platform
until the light goes off.
Fall Protection
Personal fall protection equipment (PFPE) is
required when operating this machine.
All PFPE must comply with applicable
governmental regulations, and must be inspected
and used in accordance with the PFPE
manufacturer’s instructions.
Optional Drive System Operation
1 Be sure the platform is fully lowered. The drive
function will not operate unless the platform is
fully lowered.
2 Manually engage the drive wheels by pulling
the drive wheel lever toward the tire on each
side of the machine.
3 Release the parking brake on the tongue.
OPERATING INSTRUCTIONS
ANSI, CSA and Australian models: Operate the
drive system from the platform using the drive
control box mounted next to the platform. Press
and hold the blue function enable button. Press
and hold the auto level button to raise the
outriggers.
Note: The drive system control box can be
detached from the machine and used while
standing on the ground. Remove the drive control
box from its mounting and step away from the
machine to drive.
CE models: At the ground controls, press and
hold the blue function enable button. Press and
hold the auto level button or the individual
outrigger buttons to raise the outriggers. Operate
the drive controls from the ground using the
control box mounted next to the ground controls.
Remove the drive control box from its mounting
and step away from the machine to drive.
4 Press and hold the function enable button on
the drive control handle.
5 Move the drive control handle off center. Use
the color-coded direction arrows on the control
panel to determine the direction of machine
travel.
6 Before raising the platform, lower the outriggers
and adjust to level the machine and raise the
wheels off the ground.
Note: Use the bubble level to make sure the
machine is level.