Garmin POWERLITE CINEMA 200+ - Manual (Page 14)

14
Connect your video or computer equipment to these ports:
If you connect to the Input A port, be sure to select the correct Input Signal setting for your
equipment, or the image may not display properly (see page 21).
Other Connections
■ Power cable
Plug the power cable into the projector and a grounded electrical outlet. The P power
light on the projector’s control panel turns orange when the projector is receiving power
and is in standby mode.
■ Control (RS-232C) and USB ports
Connect a computer to one of these ports to use the Cinema Color Editor software. See
page 39 for details.
Connect video equipment to any of these ports
Connect a computer to this port
D4 port
(not used
in the U.S.)
PowerLite Cinema 200+.book Page 14 Thursday, August 18, 2005 2:37 PM