Solving picture problems – Garmin POWERLITE CINEMA 200+ User Manual

Page 57

Advertising
background image

57

Solving Picture Problems

You cannot turn on the projector.

Make sure the power cord is connected, then wait a moment for the P power light to
turn orange before pressing the

Power

button.

If you’ve set the

Key Lock

, the control panel buttons are disabled; you must use the

remote control to turn on the projector (see page 24).

If you’ve set the

Child Lock

, use the remote control or press and hold the

Power

button

on the projector for at least 3 seconds to turn it on (see page 24).

No picture appears on the screen or you see the message

No Signal

displayed.

Press the

Source

button on the projector or one of the

Source

buttons on the remote

control to select the correct input source. Allow a few seconds for the projector to sync up
after pressing the button.

Press the

Blank

button on the remote control to make sure the picture hasn’t been turned

off temporarily.

Check that the P power light is green, not flashing, and the lens cover is off.

The projector may be in standby (or sleep) mode. If the P power light is orange, press the

Power

button to turn the projector back on.

Make sure your video equipment is turned on.

Make sure your cables are connected correctly (see page 13).

You’re using a computer and no picture appears on the screen.

If you’re using a PC:

Press the function key that lets you display on an external monitor. It’s often labeled with
an icon such as

, but it may also be labeled

CRT/LCD

. You may have to hold down

the

Fn

key while pressing it. Check your laptop’s manual or online help.

On most systems, the

key lets you toggle between the LCD screen and the

projector, or display on both at the same time. Allow a few seconds for the projector to
sync up after pressing it.

If the function key doesn’t let you display simultaneously on both screens, you might
need to use the Display utility in the Control Panel to make sure that both the LCD
screen and external monitor port are enabled. From the Control Panel, open the

Display

PowerLite Cinema 200+.book Page 57 Thursday, August 18, 2005 2:37 PM

Advertising