GE 24958 - Manual (Page 12)

12
Code Learning
commands.
g. Place.the.original.remote.end-to-end.with.the.
Learning.Remote.so.the.IR.transmitters.on.both.
remotes.are.directly.in.line.with.each.other..You.
may.need.to.adjust.the.height.of.either.remote.
to.achieve.this..Use.the.IR.Transmitter.Finder.
feature.to.assist.you.
h. Keep.the.distance.between.the.two.remotes.
to.approximately.1.inch.and.do.not.move.or.
change.the.distance.between.the.two.remotes.
until.you.have.learned.all.the.required.buttons.
for.that.Mode.
i. When.Learning,.do.not.release.the.button.being.
Learned.until.the.red.indicator.has.blinked.off.
for.half.a.second.
j. Avoid.learning.your.original.remote.Volume/
Mute.buttons.unless.you.are.sure.these.operate.
the.same.device.e.g..some.original.DVD.
remotes.include.TV.Volume/Mute.button.control.
and.can.be.two.different.types.of.code.
k. Avoid.learning.your.original.remote.DVD.
transport.buttons.unless.you.are.sure.these.
operate.the.same.device.e.g..some.original.TV.
remotes.include.DVD.button.control.and.can.be.
two.different.types.of.code.
l. If.learning.the.first.or.second.buttons.for.a.
Mode.results.in.continuous.errors.then.try.the.
following:
i.....End.the.Learn.session.by.pressing.the. SETUP
button.
ii....Clear.out.the.learned.commands.for.that.Mode.
iii...Check.the.IR.transmitters.are.correctly.
aligned.between.the.two.remotes.(use.the.IR.
Transmitter.Finder.facility).
iv...Adjust.the.distance.between.the.two.remotes.
to.be.closer.(e.g..half.an.inch).or.a.further.away.
(e.g..2.inches).from.each.other.
v... Try.learning.the.original.remote.for.that.Mode.
again.
If.problems.reoccur.with.the.same.button.check.
the.original.remote.button.being.learned.–.does.it.
transmit?.Does.it.operate.the.target.device?..Try.
learning.that.button.under.a.different clear.Mode...
If.it.learns.okay.then.it.is.likely.to.be.a.different.
code.type.from.the.others.and.cannot.be.learned.
under.the.same.Mode.