GE 24958 - Manual (Page 17)

17
Troubleshooting
Remote does not operate your product
1.. Select.the.mode.for.the.product.you.want.to.
control.
2.. Program.the.remote.with.a.new.code.
3.. Install.new.batteries.in.the.remote..(You.might.
have.to.reprogram.your.remote.after.installing.
new.batteries.)
4.. If.these.steps.do.not.work,.the.remote.might.not.
be.compatible.with.your.product.
Remote does not operate some
features of your product
1.. Program.remote.with.a.new.code.
2.. If.this.does.not.work,.your.remote.might.not.be.
able.to.operate.all.features.of.your.product.or.
the.button.names.might.be.different.than.your.
product.
Indicator blinks after you program a
product code
1.. This.means.the.remote.did.not.accept.the.code.
2.. Try.to.program.the.code.again.or.try.a.different.
code.
Lost Your Codes?
Enclosed.with.this.remote.is.a.sticker.on.which.
you.should.write.the.codes.for.each.device.you.
programmed..Apply.the.sticker.to.the.back.of.
the.remote.or.somewhere.convenient.for.future.
reference.
Also.on.the.sticker.is.our.website.address.which,.
should.you.lose.your.codes.or.programming.
instructions,.you.can.find.available.on.our.website:
www.jascoproducts.com