GE 200D8074P036 - Manual (Page 4)

The Performance Air-Flow System is designed to
maximize temperature control in the refrigerator
and freezer compartments. This unique special
feature consists of the Air Tower along the back
wall of the refrigerator and the Air Tunnel on the
bottom portion of the freezer rear wall. Placing
food in front of the louvers on these components will not affect performance. Although the Air Tower
and the Air Tunnel can be removed, doing so will
affect temperature performance. (For removal
instructions, on-line, contact us at
GEAppliances.com or call 800.GE.CARES.
In Canada, contact us at www.GEAppliances.ca
or call 1.800.561.3344.)
TurboCool rapidly cools the refrigerator
compartment in order to more quickly cool foods.
Use TurboCool when adding a large amount
of food to the refrigerator compartment, putting
away foods after they have been sitting out at
room temperature or when putting away warm
leftovers. It can also be used if the refrigerator has
been without power for an extended period.
Once activated, the compressor will turn on
immediately and the fans will cycle on and
off at high speed as needed for eight hours.
The compressor will continue to run until the
refrigerator compartment cools to approximately
34°F (1°C), then it will cycle on and off to maintain
this setting. After 8 hours, or if TurboCool is
pressed again, the refrigerator compartment
will return to the original setting. How to Use
Press TurboCool. The TurboCool temperature
display will show Tc and the LED will be activated.
After TurboCool is complete, the TurboCool
indicator light will go out.
NOTES: The refrigerator temperature cannot be
changed during TurboCool.
The freezer temperature is not affected
during TurboCool.
When opening the refrigerator door
during TurboCool, the fans will continue
to run if they have cycled on.
About the temperature controls.
4
The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the
freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual temperature in the
refrigerator and freezer. The actual temperature may vary slightly from the SET temperature based on
usage and operating environment.
■ On some models, setting both controls to the warmest setting until the display flashes (off) will stop
cooling in both the freezer and refrigerator compartments.
■ On other models, setting either control to the warmest setting until the display flashes (off) will stop
the cooling to the freezer and refrigerator.
■ NOTE: Turning the refrigerator off via the controls on the touch panel does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the temperature controls. If this film was
not removed during installation, remove it now.
About TurboCool. ™
(on some models)
How it Works
Not all features are on all models.
C
o
n
su
m
e
r
S
u
p
p
o
rt
T
ro
u
b
le
sh
o
o
ti
n
g
T
ip
s
O
p
e
ra
ti
n
g
In
st
ru
c
ti
o
n
s
S
a
fe
ty
In
st
ru
c
ti
o
n
s
In
st
a
ll
a
ti
o
n
In
st
ru
c
ti
o
n
s
Performance Air Flow System