Giantec tracer2000 User Manual
Page 26
tracer2000 Network DVR Hardware User’s Manual
Version 3.1
Page 18 of 31
1
6
5
9
3.2
P/T/Z Setting
The P/T/Z Setting complies with LILIN or PELCO. Protocol has been previously
attached to the COM ports. You may control the camera via arrow buttons.
In this case, you don’t need to buy dedicated P/T/Z controller.
3.3
Pin Assignment of COM2
Connect 9 PIN Female D_SUB to COM2 (Pin defines as below).
RS232 / RS422 / RS485 Connector (COM2)
Pin
No. RS232 RS422 RS485
1 DCD
TX-
DATA-
2 RX
TX+
DATA+
3 TX
RX+
4 DTR
RX-
5 GND GND GND
6 DSR
RTS-
7 RTS
RTS+
8 CTS
CTS+
9 RI
CTS-
Note: Please setup mode type by JP3.
3.4
Cable Connection
Camera input jack to COM2 for PIH-7000/7600. For example:
3.5
Jumper 3 Setting of COM2
The system default of COM2 is RS485. Adjust jumper JP3 in system for RS422,
RS232 signals as show below.