Giantec tracer2000 - Manual (Page 27)

tracer2000 Network DVR Hardware User’s Manual
Version 3.1 Page 19 of 31
Chapter V CMOS Setting
1. Introduction
This manual discusses Award TM setup program built into the ROM BIOS. The setup
program allows users to modify the basic system configuration. This special
information is then stored in battery-backed RAM so that it retains the setup information
when the power is turned off.
If system behaviors abnormal situation and you wish to check hardware values of CMOS,
you may connect a USB keyboard, restart the system by turning it OFF then ON or
pressing the “RESET” button on the system case. You may also restart by
simultaneously pressing <Ctrl>, <Alt>, and <Delete> keys. Press <Delete> key to
enter CMOS setting pages.
2. Setup Pages
Phoenix-Award BIOS CMOS Setup Utility.
Standard CMOS Feature
Advanced BIOS Feature
Advanced Chipset Feature
Integrated Peripherals
Power Management Setup
PnP / PCI Configurations
PC Health Status Frequency / Voltage Control
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Esc: Quit F9: Menu in BIOS ↑ ↓ ← →: Select Item
F10: Save & Exit Setup
Time, Date, Hard Disk Type.