Falcon 210 GEO T DL - Manual (Page 14)

14
Cleaning your cooker
Before thorough cleaning, isolate from the
electricity supply. Remember to switch on the
electricity supply before use.
Never use paint solvents, washing soda,
caustic cleaners, biological powders, bleach,
chlorine based bleach cleaners, coarse
abrasives or salt. Don’t mix different cleaning
products - they may react together with
hazardous results. Do not use a steam cleaner
on your cooker.
If you want to move your cooker for cleaning,
see the section called ‘Moving your cooker’.
All parts of the cooker can be cleaned with
hot soapy water - but take care that no surplus
water seeps into the appliance.
Stainless Steel Hob
Lift away pots or pans from hob. Remove pan
supports from spillage area and carefully place
in a sink of warm soapy water. Wipe loose
debris from hob.
Avoid using any abrasive cleaners including
cream cleaners, e.g. Cif, on brushed Stainless
Steel surfaces. For best results use a liquid
detergent e.g. Domestos Multi Surface Cleaner.
Rinse with cold water and thoroughly dry
with a clean, soft cloth. Ensure all parts are dry
before repositioning.
Hotplate burners
The burner heads and caps can be removed
for cleaning. Make sure they are absolutely dry
before replacing.
Burner head
Burner Base
When fitting burner head, ensure this locates
properly within the base.
Check burner ports are not blocked. If blockage
occurs, remove stubborn particles using a
piece of fuse wire.
Glide-Out™Grill
Before you remove any of the grill parts for
cleaning make sure that they are cool.
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods
that soil, leave to soak for a few minutes in the
sink immediately after use. Stubborn particles
may be removed from the grid by using a
nylon brush. Alternatively the grill pan can be
washed in a dish washer
To remove the grill pan support frame, pull the
grill pan forward.
Lift the grill pan clear of the support frame.
The support frame is held to the side rails by
two clips on each side.
For each side , support the side rail with one
hand and with the other hand lift the frame up
and out of the side clips.