Falcon 210 GEO T DL - Manual (Page 20)

20
Installation
Dear Installer
Before you start your installation, please
complete the details BELOW.
If your customer has a problem relating to your
installation they will be able to contact you
easily.
Installer’s Name
Installer’s Company
Installer’s Telephone number
You must be aware of the following
safety requirements & regulations
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
This appliance shall be installed in accordance with the
regulations in force and only in a well ventilated space.
Read the instructions before installing or using this
appliance.
In the UK the regulations and standards are as follows:
In your own interest and that of safety, it is law that all
gas appliances be installed by competent persons. Gas
Safe registered installers undertake to work to safe and
satisfactory standards. Failure to install the appliance
correctly could invalidate any warranty or liability
claims and lead to prosecution. The cooker must be
installed in accordance with
All relevant British Standards / Codes of Practice, in
particular BS 5440 Part 2 2000,
For Natural Gas - BS 6172 : 1990 and BS 6891 : 1998
For LP Gas - BS 5482-1:1994 (when the installation
is in a permanent dwelling), BS 5482-2:1977,
(when the installation is in a caravan or other non
permanent dwelling), or BS 5482-3:1999 , (when
the installation is in a boat).
The Gas Safety (Installation and Use) regulations
1998.
The relevant Building / IEE regulations.
In the Republic of Ireland:
The installation must be carried out by a Competent
Person and installed in accordance with the current
edition of IS 813 “Domestic Gas Installations”, the
current Building Regulations and reference should be
made to the current ETCI rules for electrical installation.
Provision of Ventilation
This appliance is not connected to a combustion
products evacuation device. Particular attention
shall be given to the relevant requirements regarding
ventilation.
In the UK:
The room containing the cooker should have an air
supply in accordance with BS 5440 Part 2 : 2000. All
rooms require an openable window or equivalent, while
some rooms require a permanent vent in addition to the
openable window. The cooker should not be installed
in a bedsitting room with volume less than 20m³. If it is
installed in a room of volume less than 5m³ an air vent
of effective area 100cm² is required; if it is installed in
a room of volume between 5m³ and 10m³, an air vent
of effective area 50cm² is required; while if the volume
exceeds 11m³, no air vent is required.
If there are other fuel burning appliances in the same
room, BS 5440 Part 2 : 2000 should be consulted to
determine the requisite air vent requirements.
In the Republic of Ireland:
Reference should be made to the current edition of
IS 813 which makes clear the conditions that must
be met to demonstrate that sufficient ventilation is
available.
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner
but NOT in a room containing a bath or shower.
NOTE:
An appliance for use on LPG shall not be installed in
a room or internal space below ground level. e.g. in a
basement.
Conversion
All models are supplied set for use on group H natural
gas. A conversion kit for LP gas is included with the
appliance. See the instructions that are supplied with
the conversion kit . After converting the appliance
please attach the Gas Conversion sticker over the
appropriate area of the data badge, this will identify the
gas type the appliance is now set for.
This appliance is designed for domestic cooking
only. Use for any other purpose could invalidate any
warranty or liability claim.