Grundig E10 - Manual (Page 12)

7 CLOCK AND TIMER FEATURES
10
SETTING THE CLOCK
The factory has set the clock to function as a 24-
hour format clock. If you prefer a 12 hour, AM/PM
clock format, see the section titled CHANGING THE
CLOCK FROM 24 TO 12 HOUR FORMAT in the
section titled SYSTEM SET CODES.
There are three methods for setting the clock.
CLOCK SET METHOD 1 – UP/HOUR and
DOWN/MIN buttons:
1. Turn the radio off. The clock digits appear in the
center of the display (40).
2. Press/release the button labeled ‘Time Set’ (18).
The clock’s digits flash in the display.
3. Within 5 seconds, set the hour using the Up/
Hour button and the minutes using the Down/
Min button (9, 10). Within 5 seconds of finishing,
press/release the TIME SET button or wait until
the clock digits stop flashing.
CLOCK SET METHOD 2 – NUMERIC KEYPAD:
When using this method, only 24 hour key-in for-
mat can be used to enter the time, even if the clock
is set for 12 hr format time display.
1. Turn the radio off. The clock digits appear in the
center of the display (40).
2. Press/release the button labeled ‘Time Set’ (18).
The clock’s digits flash in the display.
3. Use the numeric keypad to key-in the time
in 24 hour format. Within 5 seconds of finishing,
press/release the TIME SET button or wait until
the timer digits stop flashing.
CLOCK SET METHOD 3 – TUNING KNOB
1. Turn the radio off. The clock digits appear in the
center of the display (40).
2. Press/release the button labeled ‘Time Set’ (18).
The clock digits flash in the display.
3. Within 5 seconds, press/release the Up/Hour
button, then use the tuning knob to set the hour.
4. Within 5 seconds, press/release the Down/Min
button, then use the tuning knob to set the
minutes.
5. Within 5 seconds of finishing, press/release the
TIME SET button or wait until the clock digits stop
flashing.
SETTING THE TIMERS (use as wake-up alarm)
The E10 has two, independently programmable timers,
timer A and B, enabling the E10 to turn on and play
the radio for 30 minutes and then turn off. The timers
can be used as wake-up alarms. After setting a timer,
store a radio station into timer memory and activate
the timer. See the next sections titled STORING A
RADIO STATION INTO TIMER MEMORY and ACTIVAT-
ING/DEACTIVATING THE TIMER.
NOTE: A radio station must be stored into timer
memory. If this is not done, there will only be static
once the timer is activated.
When the timer activates, it turns on the radio, with
the timer activation symbol appear flashing in the
display. The radio will play the station stored into timer
memory for 30 minutes or until you turn the radio off
with the POWER/SLEEP button. The ‘snooze’ feature
can also be used (see section titled USING THE
SNOOZE FEATURE).
There are three methods to set the timer.
TIMER SET METHOD 1 – UP/DOWN MIN
BUTTONS:
1. Turn the radio off. The timer digits (38) appear in
the upper right corner of the display.
2. Press and hold down TIMER A or B button for
about two seconds. The timer digits flash in the
display.
3. Within 5 seconds, set the hour using the Up/Hour
button and the minutes using the Down/Min but-
E10 OWNER’S MANUAL