Gold's Gym XRT 75 GGSY69320 - Manual (Page 17)

17
36. Wrap the Squat Cable (73) over a 90mm Pulley
(78). Attach the Pulley to the Top Frame (6) with
an M10 x 45mm Bolt (93) and an M10 Nylon
Locknut (87).
38. Attach the Squat Cable (73) inside the Top Frame
(6) with an M10 x 70mm Bolt (134), an M10
Washer (91), and an M10 Nylon Locknut (87).
Note: It may be necessary to loosen the other
M10 x 70mm Bolt (134) to complete this step.
Retighten the Bolt when finished.
39. Lubricate an M10 x 50mm Bolt (100) with grease.
Attach a Pivot Bracket (70) to the Left Butterfly
Arm (25) with the Bolt and an M10 Nylon Locknut
(87). Do not overtighten the Locknut; the Pivot
Bracket must be able to pivot easily.
Locate the Butterfly Cable (69). Attach the
Cable to the Pivot Bracket (70) with an M8 x
20mm Shoulder Bolt (103) and an M8 Nylon
Locknut (71). Do not overtighten the Locknut;
the Cable must be able to pivot easily.
40. Wrap the Butterfly Cable (69) over a “V”-pulley
(55). Attach the “V”-pulley and a Long Cable Trap
(102) to the Butterfly Upright (3) with an M10 x
57mm Bolt (98) and an M10 Nylon Locknut (87).
Make sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
37. Wrap the Squat Cable (73) under a 90mm Pulley
(78). Attach the Pulley and a Cable Trap (68)
between the second set of holes from the top of
the Pulley Plates (63) with an M10 x 50mm Bolt
(100) and an M10 Nylon Locknut (87). Make sure
that the Cable Trap is turned to hold the Cable
in place.
36
37
38
39
40
73
73
73
69
71
25
78
78
87
68
100
134
134—Loosen
91
93
87
63
6
6
100
87
70
55
87
3
102
98
103
69
87
Lubricate