Gold's Gym XRT 75 GGSY69320 - Manual (Page 22)

22
61. Wrap the Lat Cable (88) over a 90mm Pulley
(78). Attach the Pulley and a Cable Trap (68)
between the indicated pair of Pulley Plates (63) at
the second set of holes from the bottom with an
M10 x 50mm Bolt (100) and an M10 Nylon
Locknut (87). Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
64. Attach the Lat Cable (88) to the Weight Plate (not
shown) on the bottom of the Bottom Weight (1)
with an M10 x 45mm Bolt (93) and an M10 Nylon
Locknut (87).
65. Locate the Fly Cable (85). Attach the Cable
inside the Short Base (2) with an M10 x 65mm
Bolt (18), two M10 Washers (91), and an M10
Nylon Locknut (87).
62. Wrap the Lat Cable (88) under a 90mm Pulley
(78). Attach the Pulley to the indicated bracket on
the Short Base (2) with an M10 x 45mm Bolt (93)
and an M10 Nylon Locknut (87).
61
62
63. Wrap the Lat Cable (88) under a 90mm Pulley
(78). Attach the Pulley to the indicated bracket on
the Short Base (2) with an M10 x 45mm Bolt (93)
and an M10 Nylon Locknut (87).
63
64
65
85
91
87
91
2
18
87
1 93
88
78
87
88
93
2
93
87
2
78 88
68
100
63
87
78
88