Control settings – GE ZBD6900 User Manual

Page 15

Advertising
background image

To start the dishwasher

, open the dishwasher door so that the top-of-door controls are visible. The

last used cycle will be displayed. To begin this cycle, press the START button. To select a different
cycle, press the desired Cycle Selection and Option buttons, and then press the START button.
After the door is closed and latched, the selected cycle will begin.

To interrupt/pause a cycle

, gently open the door just enough to turn off the wash motor. Do not

fully open the door until the wash action ceases.

WARNING:

Do not fully open door while the dishwasher is in operation. Quickly opening the
door while the dishwasher is operating could result in serious scalding. Be careful
when opening the door; the hot steam that escapes when the door is opened may
cause injuries. Stand back as you open the door and allow the steam to escape.

AVERTISSEMENT :

N’ouvrez pas complètement la porte lorsque la laveuse fonctionne. Une
ouverture rapide de la porte lorsque l’appareil est en fonctionnement
peut entraîner de sérieuses brûlures. Faites attention lorsque vous ouvrez
la porte; la vapeur brûlante qui s’échappe lors de l’ouverture de la porte
peut causer des blessures. Tenez vous en arrière lorsque vous ouvrez la
porte afin de permettre à la vapeur de s’échapper.

To restart the wash process,

close the door until it locks in place. There may be a time delay of

up to a few minutes because the temperature inside the dishwasher needs to stabilize before it
restarts the wash cycle.

To cancel the cycle

after it has started, press and hold the START/CANCEL button for 3 seconds.

The dishwasher will then drain and the cycle indicator lights will flash. At this point a new wash
cycle can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out after
the dishwasher drains. If you have selected a new wash cycle, remember to add more detergent to
the detergent compartment if required.

15

Start a
Wash Load

Control Panel/Operation — ZBD7000 & ZBD7100

Dishwasher

Control
Settings

4. DELAY START—

This option will allow you to delay the start time of any wash cycle except

RINSE ONLY for up to 6 hours.

• Select the delay start time you want by pressing the DELAY START button. Multiple pressing

will alternate the delay time between 2, 4 or 6 hours and OFF.

Advertising
This manual is related to the following products: