GE ZBD6900 - Manual (Page 23)

23
Water Fill
Level For best performance, check the water fill level of your
dishwasher.
Once the dishwasher is fully connected, run it through a
complete RINSE ONLY cycle to ensure it is emptying and
filling correctly. For low water pressure situations run the
RINSE ONLY cycle 3 times. Halfway through the final
RINSE ONLY cycle, pause the dishwasher and check the
water level inside the dishwasher. If the water level is not
above the minimum water level (marked on the lower
spray support tower), increase the fill level.
1. Ensure the dishwasher is not running through a cycle.
Depress the WATER TEMP button for ten seconds
until the second buzzer sounds (except on ZBD6600
models).
2. Press the START/CANCEL button to select fill time,
as per chart (65 seconds is the factory setting).
3. To test time, press DELAY START. The dishwasher will
start filling. Listen for the dishwasher to complete
filling. Once filled, the fill level must be checked to
ensure fill time is correct.
4. Once complete, press the WATER TEMP button to
exit fill time mode.
Maximum level
Minimum level
Cycle Status
Indicators Fill time
SENSING 60 seconds
WASHING 65 seconds
RINSING 70 seconds
DRYING 80 seconds
CLEAN 90 seconds
Continue to press the
START/CANCEL button until the
desired indicator is illuminated.
Care and Cleaning/Optional Accessories
Dishwasher
Change the
Dishwasher’s
Appearance for
ZBD6400 and
ZBD6500 only You can change the door panel appearance
of your dishwasher by ordering one of these
optional accessories:
• 1/4
″ Wood Panel Trim Kit
ZPF625B (Black)
ZPF625W (White)
• 3/4
″ Trimless Panel Kit
ZPF675B (Black)
ZPF675W (White)
These accessories are available at extra cost by
calling in the USA, 800.626.2002. In Canada,
call 1.888.880.3030.
Specify accessory number when ordering.