Grizzly G0453PX - Manual (Page 22)

-16- Model g0453z/g0454z (Mfg. 1/09+)
Lifting & Moving
Planer
the cabinet stand on your planer is equipped
with four lifting bars that pull out in order to lift and
place the planer, as shown in
figure 7.
figure 7. Lifting the planer with a forklift.
Lifting
Bar
(1 of 4)
Tip: When positioning the lift forks, place shop
rags or cardboard between the forks and the cabi-
net stand to avoid scratching the paint.
Assembly
To assemble your planer:
1. install (3) M8-1.25 x 20 set screws in the holes
in the bottom of the wings (see figure 8).
figure 8. Front extension wing installed (Model
g0454 shown).
set screws
hex Bolts &
Flat Washers
2. Attach the table extension wings to the planer
table with (3) M8-1.25 x 30 hex bolts, 8mm
lock washers, and 8mm flat washers, as
shown in
figure 8, but do not fully tighten the
bolts at this time.
3. using a straightedge as a guide and the
set screws for leveling control, position the
extension wings evenly with the table, then
fully tighten the hex bolts.
Note: Do not rest the straightedge on the
table rollers which would give you a false
reading.
assembly
The Model G0453Z/
G0454Z is a heavy
machine. Serious per-
sonal injury may occur
if safe moving methods
are not used. To be safe,
get assistance and use
power equipment to move
the shipping crate and
remove the machine from
the crate.