Gyration TM ULTRA CORDLESS OPTICAL MOUSE User Manual
Setting Up and Synchronizing the Ultra
Mouse and the Gyration RF Receiver
When installing the Ultra Mouse for the first time or when add-
ing additional Gyration devices to the system, it is necessary
to perform a Teach/Learn sequence to synchronize the
devices. To set up and synchronize the Ultra Mouse and the RF
1. Ensure the mouse is fully charged.
Connect the receiver cable into an available USB port and
power on your computer. Your operating system should
detect the new hardware device and initiate the installa-
tion procedure. Continue to follow the standard USB
device installation screens until installation is complete.
Press and hold the Learn button on the receiver for two
seconds and then release it. The Status light will blink
slowly, indicating the receiver is now in “Learn Mode.”
Press and release the Teach button located on the bot-
tom of the mouse handset. The Status light on the
receiver will blink rapidly for four seconds, then begin to
At this time, press the Teach button on any additional devices
(such as a keyboard, a second Ultra Mouse, or a GyroRe-
To exit Learn Mode, press the Learn button on the
receiver for two seconds. Otherwise, Learn Mode will
automatically time out after five minutes.
If more than one Gyration device is being installed on the
same system, place the receiver into Learn Mode (step 3
above) and then press the Teach button on each device before
exiting Learn Mode. However, do not press the Learn button
on the receiver for each device to be added (see “Installing 3
or More Devices” on page 12).
When the receiver is put into Learn Mode, it erases its mem-
ory of previously learned devices and looks for new devices.