GE JRS0624 - Manual (Page 11)

11
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
ge.com
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is touched. This continuous
6 second beep may be canceled.
To cancel the 6 second beep:
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the BROIL HI/LO pad.
The display shows CON BEEP
(continuous beep). Touch the BROIL
HI/LO pad again. The display shows
BEEP. (This cancels the one beep
every 6 seconds.)
Touch the START pad.
12 Hour, 24 Hour or Clock Black-Out
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour
military time clock or black-out the clock
display, follow the steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the TIMER/CLOCK pad once.
The display will show 12 hr. If this is
the choice you want touch the
START pad.
Touch the TIMER/CLOCK pad again to
change to the 24 hour military time
clock. The display will show 24 hr. If this is
the choice you want touch the START
pad.
Touch the TIMER/CLOCK pad again to
black-out the clock display. The display
will show OFF. If this is the choice you
want touch the START pad.
NOTE: If the clock is in the black-out mode you
will not be able to use the Delay Start function.
Changing the Speed of the + or – Pads
As you use the + or – pads when setting a time
or temperature, you may notice the display
changes slowly. This special feature allows you
to change the speed. To set the speed you prefer,
follow the steps below.
Touch the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Touch the + pad. The display will
show you a set speed between 1
and 5.
Touch the + pad to increase the
speed up to the number 5.
Touch the – pad to decrease the
speed down to the number 1.
Touch START to activate the setting
and leave the control set in this
special features mode.