Setting number of rings, Setting remote access code – GE 2-9950 User Manual
Page 10
10
S
ETTING
N
UMBER
OF
R
INGS
This feature allows you to set the
number of rings the answerer will
pick up after if no one answers the
phone. The default is set for four
rings.
1. While the ANSWER/MESSAGE
LED is flashing, press MENU and
the unit will announce the
current number of rings. If the
LED is steady, press MENU twice.
2. Press
or
to select: two
rings, two or four rings (toll
saver), four rings or six rings.
3. Press MENU.
The unit will confirm your selection.
S
ETTING
R
EMOTE
A
CCESS
C
ODE
1. While the ANSWER/MESSAGE
LED is flashing, press MENU to
and the unit will announce the
remote access code. If the LED is
steady, press MENU 3 times.
2. Press
or
to choose the
first number of the code.
3. Press MENU to confirm your
choice.
TIME
ANSWER
ON / OFF
SET
MENU
MESSAGE / MEMO
TIME
ANSWER
ON / OFF
SET
MENU
MESSAGE / MEMO
TIME
ANSWER
ON / OFF
SET
MENU
Note: The prompts for “Setup” will cancel after
several seconds if no buttons are pressed.