GE 25203 - Manual (Page 11)

11
5. Connect the handset cord:
Plug one end of the coiled handset cord into the side of the base and
the other end into the jack on the handset, and place the handset in
the cradle.
6. Check for a dial tone. Lift the handset and listen for a dial tone. If
you hear a dial tone, the phone is properly installed.
Attaching the Desktop Pedestal
1. Turn the phone over so that the bottom of the base is facing up
and the end with data port and line jacks is pointing away from
you.
2. Turn the desktop pedestal so that the side with four rectangle
rubber feet is facing you.
3. Insert the tabs on the pedestal into the two lower slots on the
bottom of the base, then push the pedestal downward until the
tabs on the top of the pedestal snap (lock) into place.
Connections and Setup
A B