GE 12 - Manual (Page 13)

INSTALL CENTER HINGE
ON THE LEFT
Remove the three plug buttons on the left side and
install them on the right.
Install the center hinge designed for the left side that
came with the refrigerator, with the screws, spacer
and washer(s) (on some models) that you removed
in Step 2.
Remove the tape holding the door shut.
CAUTION:
When assembled
correctly, the hinge is tight against the cabinet.
ATTENTION: The screws must be properly
tightened.
Turn the screws until snug. Then tighten
the screws a minimum of 1/2 turn using both hands.
11
Installation Instructions
13
REHANG THE FRESH FOOD DOOR
Make sure the washer(s) are in place on the bottom
hinge pin. Place the fresh food door on the bottom
hinge, close the door and tape it in place with
masking tape.
10 REHANG THE FREEZER DOOR
Place the freezer door on the center hinge over
the pin.
Raise the top hinge by hand and insert the top
hinge pin into the hole in the door. Then swing
the door shut.
12
ALIGN THE DOORS
Align the freezer door with the fresh food door so
that the gap between the doors is even.
Tighten the top hinge screws by turning them until
snug. Then turn the screws a minimum of 1/2 turn
using both hands.
Install the hinge cover over the top hinge.
13