GIGABYTE GN-BR404W - Manual (Page 60)

Multisession Configuration
The Multisession configuration allows you to setup the priority of WAN connection after
you complete the WAN configuration. In our PPPoE multi-session, three connections
will be established in three visual interfaces. Each interface owns ip address, gateway
and netmask belong each sub network. So we can use a set of rule to routing packet.
Which packets all information is matched of rules, it will be routing to different gateway.
On the PPPoE connection when established one connection peer to peer is call
session. If we have multi PPPoE connect at the same time. We must have way to
manager each session.
• Backup Session
User can set the alternate session to the main session as the backup session.
In addition, if main session is fail to connection a backup session is replace main
session.
For example,
The main session could not connect to an ISP.
Further the backup session could not connect too, the main session
Automatic : main -> backup->main->backup…….
Manual : main->backup (Backup tries to connect once only.)
Session keep alive was no response after the main session connected. Sub1 or
55