Mega Catch Mini - Manual (Page 5)

5
Installation
D
ECIDING
W
HERE TO
L
OCATE YOUR
P
ELLET
A
PPLIANCE
:
1. Remove the right and left hand cabinet sides by
loosening the three (3) T-20 Torx screws on the back
of the each panel.
2. Remove the screw located on the front of the cabinet
side, below the louvers and loosen the screw behind
the ash door.
3. Using a 5 /
16
” socket of flat head screwdriver, remove
the three (3) wood screws that are holding the
bottom of the stove to the pallet. There is one (1)
screw behind each side panel and one (1) at the back
behind the back grill.
4. Install the four (4) leveling legs into the nuts in the
base.
5. Close the side panels.
Figure 1: Screws to take out to remove stove from
pallet.
1. Check clearances to combustibles.
2. Do not obtain combustion air from an attic, garage or any unventilated space.
Combustion air may be obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect
it to an existing masonry or metal chimney (must be lined if the chimney is
over 6” (15 cm) diameter, or over 28 inches² (180 cm²) cross sectional area).
An interior vent can be used with approved pipe passing through the ceiling
and roof.
5. Locate the stove in a large and open room that is centrally located in the
house. This will optimize heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded extension
cord to reach the nearest electrical outlet.
R
EMOVING
P
ELLET
S
TOVE
F
ROM
P
ALLET
: