Motorola ME4067 Series - Manual (Page 10)

17
Using the T
elephone
18
Using the T
elephone
With more than one handset registered to the same base as you, you can make
internal calls between handsets.
Making Internal Calls
Press the key repeatedly until menu item LANGUAGE appears.
Press the
key to confirm the item.
Press or as often as necessary to select the required language.
Press the
key to confirm the selection.
Ten different languages are available for selection for each handset.
Proceed as follows to select a language:
Selecting the Language
1.
2.
3.
4.
Note: The following languages are available: English, German, Italian, France, Spainish,
Huangarian, Dutch, Polish, Swedish, Turkish.
Switching the Handset On/Off / Display Illumination
When the handset is place on the base station or charging unit, it switches on
automatically and starts to charge up. Allow the batteries to be charged for 14 hours
without interruption when the first time they are charged. The telephone does not
have an On/Off switch.
Note: The display illumination switches on automatically when the handset is removed
from the charging station or by pressing any key. It also lights up when calls are
received. The display switches off after 10 seconds if no key is pressed.
Note: If an external call is received during an internal
call, you will hear short beeps to indicate you have a call waiting. (call waiting).
1.
2.
3.
Press the key.
Press the number of the required handset (1..4).The other handset will ring.
Press the key to end the call.
Making External Calls
There are two ways to dial a number, namely direct dialing and on-hook dialing.
Press the key and wait for the dialing tone.
Dial the telephone number and complete the call.
Press the key to end the call.
Direct dialing
On-hook dialing
Dial the telephone number.
Delete any incorrect entries by pressing the
key.
Press the key. The number entered is dialed and a
connection established.
Press the key to end the call.
1.
2.
3.
1.
2.
3.
4.
Out of Range Warning
If the handset moves out of communication range with the base station, will flash.
Using Handsfree
In handsfree mode, all communication is via the handset speakerphone and
microphone, leaving your ‘hands free’. You can make a call handsfree or switch to
handsfree during a call.