Milan Technology MIL-S24002TGXX - Manual (Page 9)

6
3. Installation
This section shows the installation procedures of the switch.
Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface
where you put your Switch should be clean, smooth, level, and sturdy. Make sure there is
enough clearance around the Switch to allow attachment of cables, power cord and air
circulation.
Attaching Rubber Feet
• Make sure mounting surface on the bottom of the Switch is grease and dust free.
• Remove adhesive backing from your Rubber Feet.
• Apply the Rubber Feet to each corner on the bottom of the Switch. These footpads can
prevent the Switch from shock/vibration.
Power On
Connect the cord of power adapter to the power socket on the rear panel of the Switch. The
other side of power cord connects to the power outlet. Check the power indicator on the
front panel to see if power is properly supplied.