MITSUBISHI ELECTRIC MSH-07NV - Manual (Page 68)

68
OPERATING PROCEDURE PHOTOS
1. Removing the electrical parts
(1) Remove the screws and the top panel.
(2) Remove the screw of the cover panel. To remove the
cover panel, pull it toward you and unhook the catch-
es from the side panel.
(3) Remove the screw of the service panel. To remove the
service panel, pull it down toward you and unhook the
catches on the both sides.
2. Removing the fan motor
(1) Remove the screws of the front panel.
Open the front panel to a 45-degree angle.
Then lift it and unhook the catches to remove.
(2) Remove the propeller nut and the propeller fan.
(3) Remove the screws and the fan motor.
Disconnect the lead connectors.
11-5 MUH-24NV- MUH-24NV-
OUTDOOR UNIT
E2 E1
Photo 1
Photo 2
Photo 3
Top panel
Service panel
Panel cover
Front panel
Propeller nut
Valve bed
Lead
connectors
Separator support Motor support
Propeller
fan
Outdoor controller
board
Transformer Capacitor
Contactor
Overcurrent
relay
Terminal block Screws
Screws
OB207t-3qxp 25/9/97 9:05 PM Page 68