Marshall electronic V-R171X-DLW - Manual (Page 28)

28
■ Vectorscope Targets
Use the Vectorscope Targets option to set your Vectorscope targets up for 75% or 100% color bar signals. You can
also set your Vectorscope Targets to the OFF position.
■ Overlay Position
Use the Overlay Position option to place the Waveform, Vectorscope and Audio Level display on the Top or Bottom of
the screen while in the DLW Overlay display mode. You can also set your Overlay display to OFF.
■ Overlay Transparency
Use the Overlay Transparency option to set the transparency of the Waveform, Vectorscope and Audio Level display
while in DLW Overlay mode. Choose a value from 000-100. A low value will cause the Waveform, Vectorscope and
Audio Level data to blend into the background, while a high value will make the data appear more visible against the
video display in the background.
Ancillary Submenu
Use the Ancillary submenu to determine which ancillary packet IDs should be counted in the Ancillary Status portion of
the DLW monitor display.
■ DID/SDID
Use this section to select which packet IDs should be counted on the DLW monitor display. For example, 0x6060
would count the Timecode data packets, 0x6101 would count the EIA-708 CC data packets and 0x6102 would count
the EIA-608 CC data packets. Any ancillary packet ID can be chosen, from 0000 to FFFF.