Marshall electronic V-R171X-DLW - Manual (Page 5)

5
Installation and Initial Setup
■ Unpacking
Carefully unpack the V-R171X-DLW monitor and verify that the following items are included:
• V-R171X-DLW Monitor
• V-PS12-5V-1 Power Supply with Twist-Lock Connector
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage,
immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States,
call +1 (310) 333-0606.
■ Installation
The V-R171X-DLW can be combined with a desktop stand for desktop use. (Marshall Part V-ST15).
VESA standard 75mm hole patterns allows custom mounting installations. Marshall Electronics can provide an
optional VESA stand with pivot and tilt as well. (Marshall Part VP-LCD171H-ST-01).
■ Connections, Power-On and Initial Setup
Plug the V-PS12-5V-1 power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the Twist-Lock
connector to the back of the monitor. Connect the required cables for video signals input and output. (Power must be
applied to the V-R171X-DLW for the active loop-though output to be activated.) The monitor defaults to ‘ON’ when
power is supplied.
V-R171X-DLW with desktop stand
(Marshall Part Number V-ST15)
Desktop Stand Mounting Holes