Microtek CX4 User Manual
Page 13
2.
Connect either end of the Computer Cable to the Computer In port of the
projector. Then, connect the other end of the Computer Cable to the Monitor
Out port.
3.
If necessary, connect the computer monitor cable to the Computer Out port
of the projector.
If the functions of the wireless mouse on the Remote Control need to be operated,
please make the following connections to each signal cable according to the steps
numbered 4 ~ 6 below:
4. Connect
the
Control Cable to the Control port of the projector.
5.
Remove the computer mouse cable.
6. Connect
the
PS/2 Mouse connector of the Control Cable to the PS/2 port of
the computer.
You may connect your computer to the USB interface of the projector so to enable
the function of the wireless mouse on the remote control. Please follow the step
numbered 7 for connection.
7.
Connect one end of the USB Cable to the USB port of the projector, and
connect the other end of the USB Cable to the USB port of your computer.
8.
Tighten all connector screws to ensure secure connections.
9.
For DVI, insert one end of the DVI Cable into the DVI jack of the projector.
Insert the other end of the DVI Cable into the video-out jack on the DVI
source.
12