Miele H 5981 BP - Manual (Page 33)

Sequence of the cooking programme
when using Automatic switch-off
The following will appear in the
display:
Before the programme starts
– The cooking function and selected
temperature
– "Start at" and the start time
After the programme has started
– the heating-up phase until the set
temperature is reached
– The rising temperature is shown by
the change in the colour of the light
from yellow via orange to red, if this
is activated: see "Settings –
Speedlight – In use."
After the heating-up phase
– The "Time left" counting down
– can be followed in the display,
Shortly before the end of the
programme
– The oven heating switches off.
– The cooking programme continues
using residual heat. The residual
heat in the oven is sufficient to
complete the cooking process.
– "Energy save" will appear in the
display.
– The cooling fans continue to run, as
do the hot air fans if a "Fan" setting
has been chosen.
At the end of the cooking programme
– The hot air fans switch off,
depending on the cooking function
being used.
– The message "Programme finished"
and the O symbol appear in the
display.
– A signal will sound (provided this is
activated - see "Settings - Volume -
Buzzer tones").
After the programme has finished
– The cooling fans will continue to run
for a while after the oven has been
switched off to prevent any humidity
building up in the oven, on the
control panel or in the oven housing
unit.
The fans are sensor-controlled and
will switch off automatically. You can
change the default setting for these
(see "Settings - Cooling fan run-on").
– To save energy, the oven will switch
off automatically if it is not used
again within a certain time.
The timing depends on the settings
selected (cooking function,
temperature, duration).
Changing or deleting an entered
cooking time
Selecting "Change" brings up all the
options which can be changed.
^ Select the option you want and
change it.
Use the
U sensor to delete the entered
times.
If there is a power cut, all data entered
will be deleted.
More about manual operation
33