Meridian America G68 - Manual (Page 37)

C o n f i g u r i n g t h e
d i g i t a l s u r r o u n d
c o n t r o l l e r
3 3
Settings
The following table summarises the product settings:
Option Values Description
Tuner region: Europe/elsewhere, Japan, USA Band selection (MW/LW or AM), tuning steps, and FM
deemphasis standard. For all countries except the USA or
Japan use the Europe setting.
The fan is: used as necessary, never used Specifies how the temperature controlled fan operates.
Distance measurement: feet/inches, metres Units for displaying and entering distances.
Do your subs play to 20Hz? No, THX Ultra2/yes Subwoofer frequency response.
Boundary Gain Compensation: off, on Reduces the bass to compensate for listening positions close
to a wall.
Rear speaker separation <12"/0.3m, 12-48"/0.3-1.2m,
>48"/1.2m
Separation between rear speakers.
Copy/Zone 2 analogue out: fixed, variable Whether the Copy/Zone 2 analogue output is controlled by
the volume control.
Zone 3 analogue out: fixed, variable Whether the Zone 3 analogue output is controlled by the
volume control.
Timeout to Home buttons: on, off Whether the soft keys revert to the home keys after a delay.
Diagnostic displays: on, off Whether diagnostic displays are shown.
Is the G68 IR Controller? Auto, Controller, Not Controller Whether the product is the infra-red controller for the system.
Main System Address 1-8 Advanced setting (normally 1).
Copy System Address 1-8 Advanced setting (normally 2).
Zone System Address 1-8 Advanced setting (normally 3).
Product Address 1-8 Advanced setting (normally 1).
G Series DSP 33 31/10/03, 4:24:20 pm