Metrologic Instruments Stratos MS2x20 Series - Manual (Page 28)

23
S
CALE
C
ONFIGURATION
B
AR
C
ODES
Single Cable Scale Configuration Bar Codes
Set Scale for Single Cable Communication
If the MS2 xx0 is currently in a Dual Cable configuration, disconnect
and remove the Scale to Host cable prior to configuring the scale.
The MS2 xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
If your application requires single cable communication, scan the following bar
code to set the scale configuration to the single cable defaults as required by the
scanner.
Scale = Single Cable Interface
³ 9 9 6 0 1 2
Set the scale to communicate via the
single-cable interface.