Metrologic Instruments Stratos MS2x20 Series - Manual (Page 29)

24
S
CANNER
C
ONFIGURATION
B
AR
C
ODES
Dual Cable Scanner Configuration Bar Codes
Dual Cable Scanner Mode
The following bar codes can be used to place, as well as configure, the
scanner in Dual Cable mode.
The MS2xx0 does not need to be in scale service mode to use the
following bar codes.
Scanner = Dual Cable Mode
³ 9 9 9 9 5 3
Places the scanner in Dual Cable mode.
In a dual cable environment, the scanner
and scale work independently. In this mode
the host must have a dedicated RS232 port
to receive the scale data and the bar code
data is sent via its own cable to a separate
communication port.
Communication Port Settings:
• 9600 Baud, 8 Data Bits, 1 Stop Bit, No Parity
There are two methods of configuring the scanner to a stand-alone protocol:
• Scan the Dual Cable Mode bar code on this page (if a scale is used)
or
• If no scale is required, scan one of the single cable protocols on
pages 27 - 36 and then scan the No Scale bar code on page 48.
Dual Cable Scanner OPOS Mode
Scanner Only
Dual Cable OPOS Defaults
³ 9 9 9 9 1 1
Use this bar code when the scanner is to be
setup using the OPOS drivers in the dual
cable mode.
Communication Port Settings:
• 9600 Baud
• 8 Data Bits
• 1 Stop Bit
• No
Parity