Moffat MDW 542 - Manual (Page 9)

9
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
The dishwasher must
be switched off.
Switch on the
dishwasher by pressing
the On-Off button. The End light might
flash 5 times, for
example. The flashing is
repeated every 5
seconds.
To change the level,
press the
Programme/Cancel
button. Each time the
button is pressed the
level increases. (Level 1
follows level 10). The End light indicates
the new setting. To memorise the
operation, switch off the
dishwasher by pressing
the On-Off button.
Press and hold
Programme/Cancel
button until programme
light 1 flashes and
programme light 2
illuminates with fixed
light. Wait until programme
light 2 turns off,
programme light 1 goes
on flashing and
simultaneously End
light starts flashing. The
number of flashes of the
End light corresponds
to current level set
152952 66/0en 13-02-2006 17:05 Pagina 9