Fp1943 pilot flame, Ss38 direct vent gas stove – Monessen Hearth SS38 User Manual
Page 30
Make sure the gas valve knob is in the “OFF” position. Wait at
least five (5) minutes before start-ing maintenance.
VENTING SYSTEM
A qualified agency should examine the venting system annu-
ally.
CLEANING GLASS
Clean the ceramic glass periodically. Condensation will some-
times form on the glass during a cold startup. This is normal
for all gas stoves and stoves. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing
of the appliance can also leave a slight film on the glass. This
is a temporary problem.
Your should clean the glass after the first two weeks of use. After
that, you should clean the glass no more than two or three times
a season. Use a mild glass cleaner to clean the door. Do not
use abrasive cleaners. They will damage the glass surface.
PILOT AND BURNER FLAMES
Visually check pilot and burner flames periodically. See Figure
44 for typical burner flame. Refer to Figure 45 for typical
pilot flame.
FIREBOx CLEANING
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. Refer to Pages 25 and 26.
6. Replace door (if it has been removed).
7. Relight pilot. Refer to Page 28.
8. Turn on main burner.
CLEANING & MAINTENANCE
CAUTION
Allow glass to cool before cleaning. Do not
clean glass when it is hot. Damage could
occur.
W
ARNING
Turn off gas before servicing fireplace. It
is recommended that a qualified service
technician perform these check-ups at the
beginning of each heating season.
Figure 44 -
Typical Burner Flame
LG742
VS38 log flames
LG742
FP1943
pilot flame
Figure 45 -
Typical Pilot Flame
Thermopile
Thermocouple
FP1943
203000245
30
SS38 Direct Vent Gas Stove
W
ARNING
Make sure clearances to combustibles leave
room for maintenance and service.
W
ARNING
Carefully reassemble and reseal stove
properly after any cleaning or servicing.