McIntosh MVP861 - Manual (Page 39)

39
SETUP, con’t
Figure 58
3. To change from the default setting of OFF use the
Up or Down directional Push-buttons to select ON
followed by the SELECT Push-button.
Note: The title of the icon button-bar will change color
from yellow (the cursor color) to green indicating
the selected item.
4. Return to the Other Setup Menu by pressing the Up
directional Push-button.
5. Next continue to the COMPRESSION Settings. If no
other changes are to be made in Setup Mode at this
time, exit by pressing the Down
directional Push-
button to select the EXIT SETUP menu choice fol-
lowed by the SELECT Push-button and the MVP861
will return to normal operation.
Note: The SETUP Push-button may be also pressed to
exit the setup mode.
Compression
The Volume Compression circuit, when switched On, sup-
presses loud sounds or music that might disturb neighbors
or others not in the immediate area of the Home Theater.
Soft levels are also raised slightly so they are still listen-
able at reduced overall volume levels. This works only on a
Dolby Digital Sound Track with encoded data that supports
the compression function. To activate the Compression fea-
ture perform the following steps:
1. Press the SETUP Push-button on the supplied Remote
Control to access the On-Screen Disc Setup Menu.
Then press the Right directional Push-button to se-
lect the “etc. Setup Menu Icon Tab”. Refer to figure 55.
Note: If there is a Disc playing in the MVP861 press the
STOP Push-button twice before pressing the
SETUP Push-button.
2. Use the Down directional Push-button followed by
the SELECT Push-button on the Remote Control to se-
lect the COMPRESSION Menu. Refer to figure 58.
3. To change from the default setting of OFF use the
Up or Down directional Push-buttons to select ON
followed by the SELECT Push-button.
Note: The title of the icon button-bar will change color
from yellow (the cursor color) to green indicating
the selected item.
4. Return to the Other Setup Menu by pressing the Up
directional Push-button.
5. Next continue to the AUTO POWER MODE Settings.
If no other changes are to be made in Setup Mode at
this time, exit by pressing the Down
directional
Push-button to select the EXIT SETUP menu choice
followed by the SELECT Push-button and the
MVP861 will return to normal operation.