Maytag MCS 16021937 - Manual (Page 8)

7
How to level your
refrigerator
If your refrigerator requires an ice maker
water supply connection, proceed to How
to Connect the Water Supply for
Optional Automatic Ice Maker section
(page 6) before leveling your refrigerator.
To protect personal property or refrig-
erator from damage, observe the fol-
lowing:
➢ Protect soft vinyl or other flooring
with cardboard, rugs, or other
protective material.
➢ Do not use power tools when
performing leveling procedure.
CAUTION
MATERIALS NEEDED
➢ 3 ⁄
8
" hex head driver
➢ Level
1. Move refrigerator to final location and
plug in power cord.
2. Remove toe grille
and bottom
cover(s).
3. Turn left and right adjust-
ment screws (A) to
raise or lower front
of refrigerator.
• Make sure refriger-
ator cabinet is level
from side to side by
adjusting left and
right roller adjustment screws.
• Turn stabilizing leg clockwise until
firmly against floor.
• For Pullout Drawer Models: After
completing the above listed steps,
turn roller adjustment screws (A) 2 to
3 times counterclockwise, so that full
weight of refrigerator rests on stabi-
lizing legs.
4. Using a level, make sure front of
refrigerator is 1 ⁄
4
" (6 mm) or 1 ⁄
2
bubble
higher than back of refrigerator.
• See leveling step 3 for assistance.
5. Replace toe grille and bracket
cover(s). See markings on inside of
toe grille to insure proper placement.
• Snap bottom portion into place
first. Press down on top part of grille
until top portion snaps into place.
A
Installation,
cont.